Reflector-based phase calibration of ultrasound transducers

PLMJ Neer, Rik Vos, Nico Jong

Research output: Contribution to journalArticleAcademicpeer-review

16 Citations (Scopus)

Abstract

Recently, the measurement of phase transfer functions (PTFs) of piezoelectric transducers has received more attention. These PTFs are useful for e. g. coding and interference based imaging methods, and ultrasound contrast microbubble research. Several optical and acoustic methods to measure a transducer's PTF have been reported in literature. The optical methods require a setup to which not all ultrasound laboratories have access to. The acoustic methods require accurate distance and acoustic wave speed measurements. A small error in these leads to a large error in phase, e. g. an accuracy of 0.1% on an axial distance of 10 cm leads to an uncertainty in the PTF measurement of +/- 97 degrees at 4 MHz. In this paper we present an acoustic pulse-echo method to measure the PTF of a transducer, which is based on linear wave propagation and only requires an estimate of the wave travel distance and the acoustic wave speed. In our method the transducer is excited by a monofrequency sine burst with a rectangular envelope. The transducer initially vibrates at resonance (transient regime) prior to the forcing frequency response (steady state regime). The PTF value of the system is the difference between the phases deduced from the transient and the steady state regimes. Good agreement, to within 7 degrees, was obtained between KLM simulations and measurements on two transducers in a 1-8 MHz frequency range. The reproducibility of the method was +/- 10 degrees, with a systematic error of 2 degrees at 1 MHz increasing to 16 degrees at 8 MHz. This work demonstrates that the PTF of a transducer can be measured in a simple laboratory setting. (C) 2010 Elsevier B.V. All rights reserved.
Original languageUndefined/Unknown
Pages (from-to)1-6
Number of pages6
JournalUltrasonics
Volume51
Issue number1
DOIs
Publication statusPublished - 2011

Cite this